205-04-21 Front Drive Halfshafts 205-04-21
REMOVAL AND INSTALLATION (CONTINUED)
E5892 EN 07/2001 2002 Bantam
2. Pack the halfshaft joint with high-durability
grease (WSD-M1C230-A).
3. Make a clamp head for Special Tool 204-
169.
• Material: aluminium or steel plate
4. Position the halfshaft joint boot and secure
it using new clamping straps.
• Insert the clamp head in the special tool.
• Apply the special tool so that the clamp
head is vertical to the clamping strap
head.
NOTE: Tighten 0,8 mm thick clamping straps to
12 Nm and 1,1 mm thick clamping straps to
20 Nm.
• Tighten the clamping strap using the
special tool.
5. Attach the lower suspension arms to the
spindle carriers.
6. Lower the vehicle.
7. NOTE: Use an Allen key to stop the piston
rod from turning.
Tighten the suspension strut top nut.
To Next Page
Loading...
