205-04-23 Front Drive Halfshafts 205-04-23
REMOVAL AND INSTALLATION (CONTINUED)
E6671 EN 07/2001 2002 Bantam
4. Detach the right-hand and the left-hand
lower arms (left-hand side shown).
5. Separate and discard the boot clamps.
1. Slide the boot back onto the halfshaft.
2. Remove the grease from inside the joint.
6.
CAUTION: The inner joint must not be
bent at more than 18 degrees; the
outer joint must not be bent at more
than 45 degrees.
Remove the front drive halfshaft from the
constant velocity joint.
1. Lever open the retaining ring and hold it
open.
2. Carefully push the spindle carrier
outwards and withdraw the front drive
halfshaft.
3. Lift up the front drive halfshaft and tie it
up.
4. Remove the retaining ring from the
constant velocity joint.
7. Remove the front drive halfshaft nut and
take off the washer.
• Using a two-legged puller to press the
left-hand halfshaft out of the wheel hub
and tie it up.
To Next Page
Loading...
