501-20B-53 Occupant Restraints — Passive — Supplemental Air 501-20B-53
Bag System
REMOVAL AND INSTALLATION
Air Bag Sliding Contact (33 392 0)
Removal
WARNING: Wait at least 15 minutes after
disconnecting the battery before dis-
connecting the air bag control module
electrical connector. For all other sup-
plementary restraint system electrical
connectors, wait two minutes. Failure to
follow these procedures could increase
the possibility of accidentally deploying
the air bag(s) and pyrotechnic pre-
tensioner's.
1. Disconnect the battery ground cable.
2. Remove the steering wheel. For additional
information,
refer to Section 211-04.
3. Centre the steering wheel. Remove the key
to lock in position.
4. Detach the air bag sliding contact.
1. Disconnect the electrical connectors.
2. Release the retaining tangs.
08/2001 2002 Bantam
To Next Page
Loading...
