501-20B-61 Occupant Restraints — Passive — Supplemental Air 501-20B-61
Bag System
GENERAL PROCEDURES (CONTINUED)
8.
CAUTION: The air bag module should
not be handled immediately following
deployment as the air bag module
will be very hot.
CAUTION: After deployment, the air bag
module surface may contain deposits of
sodium hydroxide, a product of the gas
generate combustion that is irritating to
the skin. Use protective gloves when
handling any deployed air bag module.
Depress both switches to deploy the air
bag.
Two stage air bag modules
9. Connect the second test lead to the
adapter.
10.
WARNING: Before proceeding make
sure that all personnel in the vicinity
are aware that a loud noise (bang) is
about to occur. Do not let anybody
approach closer than six meters.
Failure to follow this instruction may
result in personal injury.
CAUTION: The air bag module should
not be handled immediately following
deployment, as the air bag module will
be very hot.
CAUTION: After deployment, the air bag
module surface may contain deposits of
sodium hydroxide, a product of the gas
generate combustion, which is irritating
to the skin. Use protective gloves when
handling any deployed air bag module.
Depress both switches to deploy the air
bag.
All air bag modules
11. Deployed air bag module(s) should be
sealed in a suitable bag and then disposed
of in accordance with local contaminated
waste regulations.
08/2001 2002 Bantam
To Next Page
Loading...
