211-02-40 Power Steering 211-02-40
REMOVAL AND INSTALLATION (CONTINUED)
3. Install the high-pressure line.
4. Install the low-pressure line.
5.
CAUTION: When installing a new
power steering pump make sure a
new power steering pump drive
pulley is installed.
CAUTION: Make sure the pulley is flush
with the end of the power steering pump
shaft.
Using the special tool, install a new power
steering pump drive pulley.
6. Install the auxiliary drive belt. For additional
information, refer to Section 303-05.
7. Fill and bleed the power steering system.
For additional information, refer to Section
211-00.
E6614 EN 2002 Bantam
To Next Page
Loading...
