211-02-76 Power Steering 211-02-76
REMOVAL AND INSTALLATION (CONTINUED)
7. Using the special tools, align the
crossmember.
1. Insert the guide pins through the
crossmember alignment holes.
2. Slide the locking plates into the grooves
and tighten the alignment pin sleeves.
3. Raise the crossmember engaging the
guide pins into the chassis aligning holes.
8. Install the crossmember retaining bolts.
9. Install the rear support insulator to
transmission bolt.
10. Remove the transmission jack and
alignment pins.
11. NOTE: Install the new gasket and nuts.
Tighten the exhaust front pipe flange joint
nuts.
E5862 EN 07/2001 2002 Bantam
To Next Page
Loading...
