303-01B-45 Engine — 1.6L / 1.3L RoCam 303-01B-45
IN-VEHICLE REPAIR (CONTINUED)
E6634 EN 07/2001 2002 Bantam
3. NOTE:
To prevent damage to the oil seal, do
not pull the crankshaft pulley out more than 3
mm during seal installation.
Tighten the crankshaft pulley bolt until the
oil seal is fully installed.
4. Remove the crankshaft pulley bolt.
5. Install the crankshaft pulley bolt.
6. Install the accessory drive belt cover.
7. Lower the vehicle.
8. Install the accessory drive belt.
• Turn the drive belt tensioner clockwise
and install the belt onto the pulleys.
To Next Page
Loading...
