303-01B-102 Engine — 1.6L / 1.3L RoCam 303-01B-102
DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES (CONTINUED)
E6644 EN 07/2001 2002 Bantam
7. Install the roller finger cam followers.
8. NOTE:
Make sure that the camshaft sprocket
alignment slot in the camshaft slot is
uppermost (12 o'clock) when installing the
camshaft.
NOTE:
Apply a drop of hypoid oil (WSQ-
2C9002-AA) to each cam bearing (upper
and lower) half.
Install the camshaft and the camshaft
bearing caps.
1. Install the camshaft and tighten the
bearing caps in two stages.
2. Tighten each of the camshaft bearing
cap bolts by 90° degrees in the indicated
sequence.
3. Tighten the bolts to the specified torque
in the indicated sequence.
9. Install the engine mounting bracket.
To Next Page
Loading...
