303-01B-119 Engine — 1.6L / 1.3L RoCam 303-01B-119
INSTALLATION (CONTINUED)
E6646 EN 07/2001 2002 Bantam
15. Install the coolant return hose.
16. Install the engine roll restrictor.
17.
CAUTION: The inner part of the
constant velocity joint must not be
bent at more than 18 degrees, the
outer part no more than 45 degrees.
NOTE:
Fill the joint housing with 60 grams
of high temperature grease (WSD-
M1C230-A).
NOTE:
Using the special tool, secure a new
boot clamp.
Install both front drive halfshafts.
18. Connect the lower arms to the wheel
knuckles on both sides (left-hand side
shown).
To Next Page
Loading...
