303-01D-93 Engine — 1.8L Diesel - Endura DE 303-01D-93
REMOVAL (CONTINUED)
E5886 EN 09/2001 2002 Bantam
44. CAUTION: The inner joint must not
be bent at more than 18 degrees and
the outer joint must not be bent at
more than 45 degrees.
CAUTION: After loosening the driveshaft,
immediately secure the differential,
using suitable plugs, to prevent it from
turning.
Extract the right-hand front driveshaft from
the transmission.
All vehicles
45. CAUTION: The inner joint must not
be bent at more than 18 degrees and
the outer joint must not be bent at
more than 45 degrees.
NOTE: Do not damage the boots of the drive
shaft.
Tie up the right-hand front driveshaft at the
front.
46. Remove the engine roll restrictor.
47. Preparatory measures for removing the
engine and transmission assembly.
• Position an assembly table with wooden
blocks under the engine and transmission
assembly.
• Lower the vehicle until the engine and
transmission assembly rests on the
wooden blocks.
NOTE: Make sure that the assemblies are
secure.
• Secure the engine on the assembly table
with the tensioning straps.
To Next Page
