303-01D-129 Engine — 1.8L Diesel - Endura DE 303-01D-129
ASSEMBLY (CONTINUED)
E6005 EN 09/2001 2002 Bantam
25. CAUTION: If the special tool cannot
be removed, realign the sump.
Tighten the bolts of the crankshaft oil seal
housing, working diagonally.
• Remove the locator.
26. NOTE: Use new bolts.
Fit the flywheel.
• Immobilise the crankshaft with the ring
gear.
27. Center the clutch disc on the pressure
plate.
28. Fit the clutch.
1. Place the clutch pressure plate, together
with the centered clutch disc, in the
installation position.
2. Tighten the bolts uniformly, working
diagonally.
3. Remove the special tool.
To Next Page
