303-01D-149 Engine — 1.8L Diesel - Endura DE 303-01D-149
INSTALLATION
E5915 EN 09/2001 2002 Bantam
Engine
Special Tool(s)
Remover, driveshaft
16-087
21-068 A Engine lifting
bracket
21-068 A Engine lifting
bracket
Remover/installer, radiator
hose clamps
24-003
General Equipment
Puller
New 9 mm twist drill bit
Material
Specification
Coolant L405F
High-pressure
transmission fluid
SQM-2C9008-A
Power steering
hydraulic fluid
ESPM-2C-166-H
Ford DOT 4 brake fluid
for hydraulic clutch
system
SAM-6C9103-A
High temperature
grease for transmis-
sion input shaft, guide
sleeve - clutch release
bearing, pilot bearing -
crankshaft and clutch
splines
ESD-M1C220-A
Installation
1. Preparatory operations
• Clean the internal splines of the clutch
disc, the splines on the transmission input
shaft and the clutch release bearing guide
sleeve.
• Apply a thin coating of high-temperature
grease (ESD-M1C220-A) to the
transmission input shaft, the clutch
release bearing guide sleeve, the
crankshaft pilot bearing and the clutch
splines.
To Next Page
Loading...
