303-01D-153 Engine — 1.8L Diesel - Endura DE 303-01D-153
INSTALLATION (CONTINUED)
E5915 EN 09/2001 2002 Bantam
18. CAUTION: Always tighten the front
engine mounting bracket before the
rear engine mounting bracket so that
the studs can be seated in the
elongated holes of the rear engine
mounting bracket.
Tighten the nuts of the front engine
mounting bracket.
19. Tighten the bolts and nuts of the rear
engine mounting bracket.
20. Put the transmission into 4th gear.
21. Raise the vehicle.
22. CAUTION: The inner joint must not
be bent at more than 18 degrees and
the outer joint must not be bent at
more than 45 degrees.
CAUTION: When inserting the
intermediate shaft, use the locating
sleeve (supplied with every new oil
seal), to protect the oil seal.
Install the right-hand driveshaft, together
with the intermediate shaft, in the
transmission.
To Next Page
Loading...
