303-04B-183 Fuel Charging and Controls — 1.6L / 1.3L Engine 303-04B-183
REMOVAL AND INSTALLATION (CONTINUED)
E6662 EN 07/2001 2002 Bantam
9. Remove the fuel injection supply manifold.
• Disconnect the fuel pressure regulator
vacuum line.
10. Remove the fuel injectors.
1. Remove the clip.
2. Remove the fuel injectors.
11. Remove and discard the O-ring seals.
Installation
WARNING: This procedure involves fuel
handling. Be prepared for fuel spillage
at all times and always observe fuel
handling precautions. Failure to follow
these instructions may result in per-
sonal injury.
To Next Page
Loading...
