303-04B-184 Fuel Charging and Controls — 1.6L Engine 303-04B-184
REMOVAL AND INSTALLATION (CONTINUED)
E6662 EN 07/2001 2002 Bantam
WARNING: Do not smoke or carry
lighted tobacco or open flame of any
type when working on or near any fuel
related components. Highly flammable
mixtures are always present and can ig-
nite. Failure to follow these instructions
may result in personal injury.
1.
CAUTION: Do not use silicone grease
to lubricate the O-ring seals, as it will
block the fuel injectors.
NOTE:
Install new O-ring seals.
NOTE: Lubricate the O-ring seals with clean
engine oil to aid installation.
NOTE: Install new cable ties.
To install, reverse the removal procedure.
To Next Page
Loading...
