303-04D-13 Fuel Charging and Controls — 1.8L Diesel Engine 303-04D-13
REMOVAL AND INSTALLATION (CONTINUED)
E6448 EN 09/2001 2002 Bantam
19. Install the special tool to the cylinder block.
CAUTION: When turning the
engine to lock the crankshaft, do so slowly
to avoid bending the special tool.
Turn the engine clockwise until the
crankshaft locks against the special tool.
20. Install the special tool, to lock the camshaft.
21. Install the special tool, to lock the fuel
injection pump.
22. Remove and discard the timing belt. For
additional information,
refer to Section 303-01C.
23. Remove the accelerator cable adjuster clip.
To Next Page
Loading...
