303-04D-21 Fuel Charging and Controls — 1.8L Diesel Engine 303-04D-21
REMOVAL AND INSTALLATION (CONTINUED)
E6448 EN 09/2001 2002 Bantam
17. Remove the special tool from the cylinder
block.
18. Lower the vehicle.
19. Turn the engine clockwise two full turns
until the slot in the fuel injection pump
pulley reaches the 11 o'clock position.
20. Raise and support the vehicle. For
additional information,
refer to Section 100-02.
21. Install the special tool to the cylinder block.
CAUTION: When turning the
engine to lock the crankshaft, do so slowly
to avoid bending the special tool.
Turn the engine clockwise until the
crankshaft locks against the special tool.
22. Remove the special tool from the cylinder
block.
23. Install the remainder of the components in
reverse order.
To Next Page
Loading...
