303-06-205 Starting System 303-06-205
DIAGNOSIS AND TESTING (CONTINUED)
E1017 EN 07/2001 2002 Bantam
CONDITIONS
DETAILS/RESULTS/ACTIONS
A2: CHECK THE BATTERY VOLTAGE
1
Check the battery. Refer to Section 414-00.
• Is the battery OK?
Yes
GO TO
A3
No
CHARGE or INSTALL a new battery as re-
quired. Refer to Section 414-00. TEST the
system for normal operation.
A3: CHECK SWITCHED POWER SUPPLY TO THE SOLENOID
1.
Solenoid single
pin
2.
3
Measure the voltage between the starter motor
solenoid connector single pin, circuit 50
(GY/BK) and ground when the starter is
operated.
• Is the voltage greater than 10 volts?
Yes
GO TO
A4
No
GO TO
A6
A4: CHECK B+ TO THE STARTER
1.
To Next Page
Loading...
