204-01-9 Front Suspension 204-01-9
REMOVAL AND INSTALLATION (CONTINUED)
E1056 EN 06/2001 2002 Bantam
Installation
CAUTION: Avoid any impact on the
wheel bearing seals.
CAUTION: Make sure the wheel bearing
seals are clean.
1. NOTE: Lubricate the bore of the wheel
knuckle with engine oil.
Using the special tools, install the bearing
to the wheel knuckle.
2. NOTE: Make sure the ends of the circlip are
positioned in line with the lower ball joint
housing.
Install the circlip to the wheel knuckle.
3. Using the special tools, install the wheel
hub to the wheel knuckle.
4. Install the wheel knuckle. For additional
information,
refer to Wheel Knuckle in this section.
To Next Page
Loading...
