308-03-81 Manual Transaxle 308-03-81
DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES (CONTINUED)
E1165 EN 07/2001
7. CAUTION: Mark the components to
show the way the shift ring and
synchronizer clutch hub fit together.
Dismantle the synchronizer assembly.
1. Shift ring
2. Synchronizer spring
3. Blocker bar
4. Synchronizer clutch hub
8. NOTE: Insert the thrust ring into the oil slinger
bore.
Detach the output shaft bearing cone.
1. Remove the snap-ring.
• Locate the expanding claws underneath
the bearing cone.
2. Pull off the bearing cup.
Assembly
CAUTION: Lay the double synchronizer
units in transmission fluid before install-
ing them.
1. Carefully clean and check all sliding parts
and coat with transmission fluid before
assembling.
To Next Page
Loading...
