308-03-82 Manual Transaxle 308-03-82
DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES (CONTINUED)
E1165 EN 07/2001
2. Fit the output shaft bearing cone.
• Heat the bearing cone evenly to about
80 °C and slide it onto the output shaft.
• Fit the snap-ring.
3. NOTE: Assembly markings on the shift ring
and synchronizer clutch hub.
Assemble the synchronizer clutch.
1. Synchronizer clutch hub
2. Place the shift ring onto the synchronizer
clutch hub.
3. Install the blocker bar.
4. Install the synchronizer spring.
4. Fit the 1st gearwheel and the reverse
gearwheel with the synchronizer clutch and
synchronizer assembly on the output shaft.
1. 1st gearwheel
2. Inner synchronizer ring
3. Synchronizer cone
4. Outer synchronizer ring
5. 1st/2nd gear synchronizer clutch with
reverse gearwheel
6. Snap-ring
To Next Page
Loading...
