308-03-89 Manual Transaxle 308-03-89
ASSEMBLY (CONTINUED)
E4462 EN 07/2001
6. Fit the shift rod with the locking plate.
7. Prepare input and output shaft for
installation.
1. Bring the input shaft and output shaft into
mesh with one another.
2. Move the 1st/2nd gear selector fork into
position.
3. Move the 3rd/4th gear selector fork into
position.
8. Install the input shaft and output shaft.
• Attach a rubber band to the auxiliary shift
rod as an aid to assembly.
1. Guide the input shaft in about 50 mm
and angle it slightly to the side.
2. Put in the output shaft to about the same
level as the input shaft and engage the
gearwheel teeth again.
• Move the input and output shafts into
their final positions.
9. Install the shift rod guide sleeve.
1. Slide the guide sleeve into position.
2. Fit the lower snap-ring.
To Next Page
Loading...
