308-03-102 Manual Transaxle 308-03-102
INSTALLATION (CONTINUED)
E6701 EN 07/2001
14. Install the engine roll restrictor.
15. CAUTION: The inner joint must not
be bend more than 18 degrees, the
outer joint must not be bend more
than 45 degrees.
CAUTION: Use the installation sleeve
(supplied with every new oil seal) to
protect the oil seal when inserting the
front halfshaft.
NOTE: Fill the inner constant velocity housing
with High-durability grease.
NOTE: Make sure the snap rings are securely in
place.
Install the left-hand and the right-hand
halfshaft in the transaxle together with new
snap rings.
16. Install the left-hand and right-hand lower
arm ball joints.
To Next Page
Loading...
