MPC5604B/C Microcontroller Reference Manual, Rev. 8
Freescale Semiconductor 915
Deserial Serial
Peripheral Interface
Removed all references to DSI (Deserial Serial Interface) and CSI (Combined Serial
Interface) (device does not implement DSI and CSI)
Removed all references to DMA (DSPI does not support DMA in this device)
DSPI Module Configuration Register (DSPIx_MCR): Replaced the reset value of MDIS
bitfield with ‘1’. Made same modification on DSPIx_MCR field descriptions.
Section 19.4.2, “Signal names and descriptions”: Formatted all CS signals as “CSn_x”
Section 19.5, “Memory map and register description”: Removed all DMA requests content
Section 19.5.4, “DSPI Clock and Transfer Attributes Registers 0–5 (DSPIx_CTARn)”:
Changed number of clock and transfer attribute registers from eight to six
Section 19.5.5, “DSPI Status Register (DSPIx_SR)”: Modified first paragraph
DSPI detailed memory map: Added ‘Location’ column as navigational aid
Baud rate computation example: Changed f
SYS
from 100 MHz to 64 MHz and updated
baud rate accordingly
Section 19.6, “Functional description”: Removed all DMA requests content and eDMA
controller content
Section 19.7.1, “How to change queues”: Modified list of events: Was 1–11, is 1–7
Updated Section 19.7.3, “Delay settings”
Table B-4. Changes between revisions 2 and 4 (continued)
Chapter Description
To Next Page
Loading...
