MPC5604B/C Microcontroller Reference Manual, Rev. 8
Freescale Semiconductor 919
Cross Triggering Unit CTU register map: Added ‘Location’ column and base address
Trigger source: Corrected eMIOS channel assignment on CTU inputs
Amended end of Section 29.4.1, “Event Configuration Registers (CTU_EVTCFGRx) (x =
0...3163)”
Safety Section 27.1.1.1, “Overview”: Replaced AIPS with PBRIDGE
Section 27.2, “Software Watchdog Timer (SWT)”: Replaced “Software” by “System”
Replaced “system watchdog” with “software watchdog” throughout chapter
System Status and
Configuration Module
Section 28.2.2, “Register description”: Updated introduction and applied LSB=0 numbering
to field bit numbers where needed
Module memory map: Added ‘Location’ column as navigational aid
Error Configuration (ERROR) field descriptions: Replaced “AIPS” with “PBRIDGE” in RAE
field description
System Memory Configuration Register (MEMCONFIG) field descriptions: Modified
descriptions of fields PRSZ and PVLB to replace “Program Flash” and “Instruction Flash”
with “Code Flash”
Wakeup Unit Updated Section 29.1, “Overview”
Updated Wakeup unit block diagram
WKPU memory map: Added ‘Location’ column as navigational aid
Interrupt vector 1: Updated PB[3]
Interrupt vector 2: Updated PG[3] and PG[5]
Wakeup/Interrupt Status Flag Register (WISR): Updated footnote
Updated WISR field descriptions
Interrupt Request Enable Register (IRER): Updated footnote
Wakeup Request Enable Register (WRER): Updated footnote
Wakeup/Interrupt Rising-Edge Event Enable Register (WIREER): Updated footnote
Wakeup/Interrupt Falling-Edge Event Enable Register (WIFEER): Updated footnote
Wakeup/Interrupt Filter Enable Register (WIFER): Updated footnote
Wakeup/Interrupt Pullup Enable Register (WIPUER): Updated footnote
Section 29.5.3, “External wakeups/interrupts”: Replaced “supports up to two interrupt
vectors” with “supports up to three interrupt vectors”
Periodic Interrupt Timer Replaced PIT_RTI with PIT throughout document
Tables PIT memory map and Timer Channel n: Added “Location” column as navigational
aid
Section 30.6.1, “Example configuration”: Removed RTI lines from code
Voltage Regulators and
Power Supplies
Updated figure
Updated Section 33.1.1, “High power regulator (HPREG)”
Section 33.3, “Power domain organization”: Modified number of power domains; was two,
is three
Appendix B: Register
Map
Module base addresses:
– Changed Periodic Interrupt Timer (PIT/RTI) to Periodic Interrupt Timer (PIT)
– Changed CTU-LITE to CTU
Detailed register map:
– Changed register name PIT_RTI Control to PIT_Control
– Changed Periodic Interrupt Timer (PIT/RTI) to Periodic Interrupt Timer (PIT)
– Changed CTU-LITE to CTU
– Updated description of RSER
– Replaced “Program Flash A Configuration” with “Code Flash A Configuration”
– Replaced registers IFER, IFMI, IFMR, IFCR2n and IFCR2n+1 with “Reserved” for
LINFlex modules 1, 2 and 3
Table B-4. Changes between revisions 2 and 4 (continued)
Chapter Description
To Next Page
Loading...
