MPC5604B/C Microcontroller Reference Manual, Rev. 8
922 Freescale Semiconductor
Inter-Integrated Circuit
Bus Controller Module
- Replaced “I2C_DMA“ “I2C“ through whole chapter.
- Section 26.1.1, “Overview”: Replaced the capacitance value from “400pF“ to “50pF“.
- Ta bl e 3 84: Removed Mode column.
Enhanced Modular I/O
Subsystem
Replaced the entire chapter.
Analog-to-Digital
Converter
Replaced the entire chapter.
Cross Triggering Unit Table 454: Corrected eMIOS channel assignment on CTU inputs.
System Status and
Configuration Module
- Section 28.4.2, “System Memory Configuration Register (MEMCONFIG)”: Updated
register definition.
- Removed section “Initialization/Application Information“.
Wakeup Unit - Related Bit12 and Bit13 to the wakeup line respectively 19 and 18 of the following register:
WISR, IRER, WRER, WIREER, WIFEER, WIFER, WIPUER.
- WKUP line 0: Previously = RTC/API; Now = API.
- 'Old'WKUP line 1 -> Now WKUP line 19.
- 'New' WKUP line 1 -> RTC.
- Replaced “NMI[0]“ whti [NMI].
- Moved the note of “Interrupt Vector 2”, this note is valid only for PF[13], PG[3] and PG[5].
- Figure 432: Replaced “0-18” instead “0-19”.
- Figure 443: updated in according to the previous change.
- Section 29.2, “Features”:
- Updated the “External wakeup/interrupt support” list to explain that system interrupt
vectors are 3.
- Updated the “On-chip wakeup support“ list to explain that wakeup spurces are 2.
- Section 29.4.1, “Memory map”: Table 411 Removed redundant rows.
Periodic Interrupt Timer Figure 445: Replaced “Timer 3” with “Timer 5”.
Real Time Clock /
Autonomous Periodic
Interrupt
- Added “/Autonomous Periodic Interrupt“ in the title.
- Figure 13-1: Updated to explain that “RTC Rollover wakeup“ and “RTC cnt_or_rlovr“ are
not connected on MPC5604B.
- Figure 13.4: Removed section “Test mode“.
- Removed section “External Signal Description“.
Voltage Regulators and
Power Supplies
Aligned the electrical value with data sheet.
Table B-5. Changes between revisions 1 and 2 (continued)
Chapter Description
To Next Page
Loading...
