150 Upgrade and Maintenance Manual RX2540 M2
Hard disk drives (HDD) and solid state drives (SSD)
Figure 47: Inserting the 3.5-inch HDD module
Ê Insert the HDD module into a drive bay and carefully push back as far as it
will go (1).
Ê Close the locking lever to lock the HDD module in place (2).
I Configuring the RAID array, refer to the documentation of the RAID
controller, used in your HDD configuration, see "Documents you need at
hand" on page 46.
7.2.2.4 Concluding steps
Ê No steps needed.
7.2.3 Removing 3.5-inch HDD modules
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less
To Next Page
Loading...
