RX2540 M2 Upgrade and Maintenance Manual 521
System board and components
14.3.2.2 Removing the UFM
Figure 392: Removing the UFM (A)
Ê Remove the nylon screw on the defective UFM.
Ê Disconnect and remove the defective UFM.
The UFM spacer remains on the system board.
V CAUTION!
UFM contains customer information (e.g. IP address, License etc.). After
removing the UFM, you must pass the UFM to the customer.
14.3.2.3 Concluding steps
Ê "Reassembling" on page 73
Ê "Connecting the power cord" on page 79
Ê "Switching on the server" on page 82
Ê "Resuming BitLocker functionality" on page 120
To Next Page
Loading...
