RX2540 M2 Upgrade and Maintenance Manual 153
Hard disk drives (HDD) and solid state drives (SSD)
7.2.3.3 Installing a 3.5-inch dummy module
V CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 49: Installing a 3.5-inch dummy module
Ê Slide the 3.5-inch dummy module into the drive bay until it locks in place (1).
Ê Insert the lock (2).
I Insert the lock only when there is no backplane behind this bay.
7.2.3.4 Concluding steps
Ê Refer to the RAID documentation configuring the RAID, see "Documents
you need at hand" on page 46.
To Next Page
Loading...
