274 Upgrade and Maintenance Manual RX2540 M2
Expansion cards and backup units
Ê "Reassembling" on page 73
Ê Connect all external cables to the expansion card(s).
Ê "Connecting the power cord" on page 79
Ê "Switching on the server" on page 82
Ê If applicable, "Updating RAID controller firmware" on page 106.
Ê If applicable, "Enabling Option ROM scan" on page 107.
Ê "Enabling SVOM boot watchdog functionality" on page 114
Ê "Resuming BitLocker functionality" on page 120
8.5.4 Removing an expansion card from riser module 2
8.5.4.1 Preliminary steps
Ê If applicable, "Locating the defective server" on page 61
Ê "Suspending BitLocker functionality" on page 95
Ê "Shutting down the server" on page 65
Ê Remove all external cables from the expansion card to be removed.
I If there is a cable installed to an expansion card in the upper slot, see
section "Note for installation with expansion cards in slot 5 and slot
11" on page 83.
Ê "Disconnecting the power cord" on page 66
Ê "Getting access to the component" on page 68
Ê If applicable, disconnect internal cables from the expansion cards.
Ê If applicable, "Removing an SFP+ transceiver module" on page 252.
Ê Remove the riser module 2 as described in section "Removing the riser
module 2 (HL)" on page 87
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PZ2 / (+) No. 2 screw driver / nut driver 5 mm
To Next Page
Loading...
