262 Upgrade and Maintenance Manual RX2540 M2
Expansion cards and backup units
8.4.3.2 Removing an expansion card
Ê If applicable, "Removing an SFP+ transceiver module" on page 252.
Ê "Removing expansion cards" on page 258
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing a slot bracket" on
page 248.
8.4.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 243.
Ê "Installing an expansion card" on page 256.
Ê If applicable, "Installing SFP+ transceiver modules" on page 249.
8.4.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 559.
8.4.3.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect an FBU cable to the expansion card as described in
section "Connecting the FBU to the RAID controller" on page 318.
8.4.3.6 Concluding steps
Ê "Reassembling" on page 73
Ê Connect all external cables to the replaced expansion card.
Ê "Connecting the power cord" on page 79
Ê "Switching on the server" on page 82
Ê "Enabling replaced components in the system BIOS" on page 115
Ê If applicable, inform the customer about changed WWN and MAC
addresses. For further information, refer to section "Looking up changed
MAC / WWN addresses" on page 122.
Ê If applicable,"Updating RAID controller firmware" on page 106.
To Next Page
Loading...
