312 Upgrade and Maintenance Manual RX2540 M2
Expansion cards and backup units
Ê Remove the GPGPU card as described in section "Removing a GPGPU
card (FL)" on page 298.
Figure 206: Removing a riser card
Ê Remove four screws (see circles).
Ê Take the riser card out of the riser card holder.
8.6.6.3 Installing the new GPGPU card
Ê Install the new riser card as described in section "Installing a riser card with
one PCIe slot Gen3 x16" on page 285.
Ê Install the new GPGPU card as described in section "Installing a GPGPU
card in a riser module" on page 286.
Ê If applicable, install the riser module 1 as described in section "Installing the
riser module 1" on page 289.
Ê If applicable, install the riser module 2 as described in section "Installing the
riser module 2 (FL)" on page 301.
8.6.6.4 Connecting cables to the expansion cards
Ê If applicable, connect internal cables to the expansion cards.
I For a complete cabling overview, please refer to section "List of used
cables" on page 559.
To Next Page
Loading...
