RX2540 M2 Upgrade and Maintenance Manual 279
Expansion cards and backup units
8.5.5.6 Concluding steps
Ê "Reassembling" on page 73
Ê Connect all external cables to the replaced expansion card.
Ê "Connecting the power cord" on page 79
Ê "Switching on the server" on page 82
Ê "Enabling replaced components in the system BIOS" on page 115
Ê If applicable, inform the customer about changed WWN and MAC
addresses. For further information, refer to section "Looking up changed
MAC / WWN addresses" on page 122.
Ê If applicable,"Updating RAID controller firmware" on page 106.
Ê "Enabling SVOM boot watchdog functionality" on page 114
Ê "Resuming BitLocker functionality" on page 120
8.5.6 Replacing a riser card
8.5.6.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 95
Ê "Disabling SVOM boot watchdog functionality" on page 96
Ê "Locating the defective server" on page 61
Ê "Shutting down the server" on page 65
Ê "Disconnecting the power cord" on page 66
Ê Remove all external cables from the expansion card to be replaced.
Ê "Getting access to the component" on page 68
Ê If applicable, disconnect internal cables to the expansion card.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PZ2 / (+) No. 2 screw driver / nut driver 5 mm
To Next Page
Loading...
