RX2540 M2 Upgrade and Maintenance Manual 525
System board and components
Ê Connect the UFM to the system board and the remaining UFM spacer (1).
Ê Fasten the UFM to the UFM spacer with the nylon screw (2).
14.3.3.4 Concluding steps
Ê "Reassembling" on page 73
Ê "Connecting the power cord" on page 79
Ê "Switching on the server" on page 82
Ê "Enabling SVOM boot watchdog functionality" on page 114
Ê "Resuming BitLocker functionality" on page 120
14.3.3.5 Software configuration
In order to setup the ESXi configuration, the VMware ESXi Recovery Tools CD
is required. An ISO image of the CD is available from the Fujitsu service
partners portal at the following https address:
https://globalpartners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/
Pages/default.aspx
Ê Sign in and choose your PRIMERGY server.
Ê Select the Software & Tools Documentation category.
Ê Download the desired ESXi Recovery CD ISO image, listed under Tools.
Ê Unpack and burn the image to a CD.
Ê Ensure that no other USB storage device is connected to the server beside
the UFM.
Ê Insert the Recovery Tools CD into your CD / DVD drive and reboot the
server.
The server should now boot from the Recovery Tools CD.
Ê Follow the on-screen instructions to initiate the installation.
After the flash process is complete, you will be asked to reboot the system.
I For Japan
In order to setup the ESXi, please refer to the corresponding version of
the "VMware vSphere Software Description" from the following URL and
reinstall ESXi to the USB Flash Module.
http://jp.fujitsu.com/platform/server/primergy/software/vmware/manual/
To Next Page
Loading...
