RX2540 M2 Upgrade and Maintenance Manual 555
System board and components
Ê "Opening the load plate" on page 364
14.7.1.4 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section "List of used cables" on page 559.
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: see section "Installing CPU heat sinks" on page 383.
– Memory modules: see section "Installing a memory module" on
page 357.
I Install all memory modules into their original slots.
– Expansion cards: see section "Installing expansion cards" on page 255.
I Install all expansion cards into their original slots.
– UFM(if applicable): see section "Installing the UFM" on page 517.
– TPM (if applicable): see section "Installing the TPM" on page 526.
– DynamicLoM module (if applicable) see section "Installing the
DynamicLoM module" on page 333 or the three screws that are installed
in place of the DynamicLoM module.
– SATA DOM (if applicable): see section "Installing the SATA DOM" on
page 537.
– iRMC microSD card (if applicable): see section "Installing the iRMC
microSD card" on page 541.
Ê "Installing the fan box" on page 399
Ê "Reassembling" on page 73
Ê Install the PSUs, see section "Installing a hot-plug PSU" on page 134.
Ê "Connecting the power cord" on page 79
Ê Connect all external cables.
Ê "Switching on the server" on page 82
To Next Page
Loading...
