RX2540 M2 Upgrade and Maintenance Manual 65
Basic hardware procedures
4.2 Shutting down the server
V CAUTION!
For further safety information, please refer to chapter "Important
information" on page 49.
I This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Perform the required procedures described in the preliminary steps of each
upgrade or maintenance task.
Ê "Verifying and configuring the backup software solution" on page 99.
Ê In case of Multipath I/O environments, please refer to section "Note on
server maintenance in a Multipath I/O environment" on page 100.
Ê "Removing backup and optical disk media" on page 99.
Ê Shut down the server.
I If the system is running an ACPI-compliant operating system,
pressing the On/Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section "Locating the defective server" on page 61.
To Next Page
Loading...
