RX2540 M2 Upgrade and Maintenance Manual 87
Basic hardware procedures
Figure 19: Installing the riser module 1 (B)
Ê Fasten the riser module with five screws (see circles).
Ê If applicable, install SFP+ transceiver modules into the new expansion card,
as described in section "Installing SFP+ transceiver modules" on page 249.
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 559.
Ê If applicable, connect an FBU cable to the expansion card as described in
section "Connecting the FBU to the RAID controller" on page 318.
4.8.1.3 Removing the riser module 2 (HL)
Ê If applicable, "Removing an SFP+ transceiver module" on page 252.
To Next Page
Loading...
