RX2540 M2 Upgrade and Maintenance Manual 187
Hard disk drives (HDD) and solid state drives (SSD)
7.3.5.5 Concluding steps
Ê "Installing the fan box" on page 399
Ê "Reassembling" on page 73
Ê "Connecting the power cord" on page 79
Ê "Switching on the server" on page 82
Ê "Resuming BitLocker functionality" on page 120
7.4 2.5-inch HDD/SSD configurations
7.4.1 Mounting order for 2.5-inch HDDs/SSDs
Maximum configuration: 24x 2.5-inch HDDs
Basic information
– If only one HDD module is installed, the HDD module will be installed in
position 1. Empty bays must be equipped with a dummy module.
– It is necessary to install dummy locks to all unused HDD bays (eight pieces).
I The mounting order described above is only relevant for the factory
manufacturing process. In case of upgrading a system you need not
consider this mounting sequence.
To Next Page
Loading...
