168 Upgrade and Maintenance Manual RX2540 M2
Hard disk drives (HDD) and solid state drives (SSD)
I If there is a jumper installed on the 4x 3.5-inch HDD SAS backplane,
remove 2-pins connector X13 (part number of backplane
A3C40173250).
Figure 65: Installing the 3.5-inch HDD SAS backplane 2
Ê At a slight angle insert the 3.5-inch HDD SAS backplane 2 between the
punching and the centering pin (1). See section "Installing the 4x 3.5-inch
HDD SAS backplane 1" on page 163.
Ê Fold back the 4x 3.5-inch HDD SAS backplane 2.
I Take care that the OOB connector will not be damaged! (2)
To Next Page
Loading...
