RX2540 M2 Upgrade and Maintenance Manual 533
System board and components
Slowly and carefully increase the pressure on the screw until it begins
to turn. The effort when loosing the screw should be as low as
possible.
Otherwise the thin metal bar may break, rendering it impossible to
loosen the screw.
Ê Remove the TPM screw.
Ê Remove the defective TPM on the upper side of the system board.
Figure 403: Removing the TPM spacer
Ê Using a pair of flat nose pliers, press together the hooks on the TPM spacer
(see close-up) and remove it from the system board.
I If the TPM is to be replaced, the TPM spacer may remain on the
system board.
To Next Page
Loading...
