1-5
display ip routing-table acl
Syntax
display ip routing-table acl acl-number [ verbose ]
View
Any view
Default Level
1: Monitor level
Parameters
acl-number: Basic ACL number, in the range of 2000 to 2999.
verbose: Displays detailed routing table information, including that for inactive routes. With this
argument absent, the command displays only brief information about active routes.
Description
Use the display ip routing-table acl command to display information about routes permitted by a
specified basic ACL.
This command is intended for the follow-up display of routing policies.
If the specified ACL does not exist or it has no rules configured, the entire routing table is displayed.
Examples
# Define basic ACL 2000 and set the route filtering rules.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.0.0 0.0.255.255
[Sysname-acl-basic-2000] rule deny source any
# Display brief information about active routes permitted by basic ACL 2000.
[Sysname-acl-basic-2000] display ip routing-table acl 2000
Routes Matched by Access list : 2000
Summary Count : 6
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 Direct 0 0 10.1.1.2 Vlan1
10.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0
10.1.2.0/24 Direct 0 0 10.1.2.1 Vlan2
10.1.2.1/32 Direct 0 0 127.0.0.1 InLoop0
10.1.3.0/24 Direct 0 0 10.1.3.1 Vlan1
To Next Page
Loading...
Need help?
General