H3C S5120-SI Series Command Reference

1-4
Field Description
Interface Outbound interface for packets to be forwarded along the route
BkNexthop Backup next hop
BkInterface Backup outbound interface
RelyNextHop The next hop address obtained through routing recursion
Neighbour Neighboring address determined by Routing Protocol
Tunnel ID Tunnel ID
Label Label
Route status:
Active This is an active unicast route.
Adv This route can be advertised.
Delete This route is deleted.
Gateway This is an indirect route.
Holddown Number of holddown routes.
Int
The route was discovered by an Interior Gateway Protocol
(IGP).
NoAdv
The route is not advertised when the router advertises routes
based on policies.
NotInstall
Normally, among routes to a destination, the route with the
highest priority is installed into the core routing table and
advertised, while a NotInstall route cannot be installed into the
core routing table but may be advertised.
Reject
The packets matching a Reject route will be dropped.
Besides, the router sends ICMP unreachable messages to
the sources of the dropped packets. The Reject routes are
usually used for network testing.
Static
A static route is not lost when you perform the save operation
and then restart the router. Routes configured manually are
marked as static.
Unicast Unicast routes
Inactive Inactive routes
Invalid Invalid routes
WaitQ The route is the WaitQ during route recursion.
TunE Tunnel
State
GotQ The route is in the GotQ during route recursion.
Age
Time for which the route has been in the routing table, in the sequence of hour,
minute, and second from left to right.
Tag Route tag

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English