H3C S5120-SI Series Command Reference

1-9
display rmon statistics
Syntax
display rmon statistics [ interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display rmon statistics command to display RMON statistics.
This command displays the interface statistics during the period from the time the statistics entry is
created to the time the command is executed. The statistics are cleared after the device reboots.
Related commands: rmon statistics.
Examples
# Display RMON statistics for interface GigabitEthernet 1/0/1.
<Sysname> display rmon statistics GigabitEthernet 1/0/1
EtherStatsEntry 1 owned by null is VALID.
Interface : GigabitEthernet1/0/1<ifIndex.3>
etherStatsOctets : 43393306 , etherStatsPkts : 619825
etherStatsBroadcastPkts : 503581 , etherStatsMulticastPkts : 44013
etherStatsUndersizePkts : 0 , etherStatsOversizePkts : 0
etherStatsFragments : 0 , etherStatsJabbers : 0
etherStatsCRCAlignErrors : 0 , etherStatsCollisions : 0
etherStatsDropEvents (insufficient resources): 0
Packets received according to length:
64 : 0 , 65-127 : 0 , 128-255 : 0
256-511: 0 , 512-1023: 0 , 1024-1518: 0
Table 1-6 display rmon statistics command output description
Field Description
EtherStatsEntry
The entry of the statistics table, corresponding to the MIB node
etherStatsIndex.
VALID
Status of the entry identified by the index (VALID means the
entry is valid, and UNDERCREATION means invalid. You can
use the display rmon command to view the invalid entry; while
with the display current-configuration and display this
commands you cannot view the corresponding rmon
commands.), corresponding to the MIB node etherStatsStatus.
Interface
Interface on which statistics are gathered, corresponding to the
MIB node etherStatsDataSource.

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English