2-7
View
Any view
Default Level
2: System level
Parameters
by-linenum: Identifies each line of displayed information with a line number.
Description
Use the display saved-configuration command to display the contents of the configuration file saved
for the next startup of the device.
During device management and maintenance, you can use this command to check whether important
configurations are saved to the configuration file to be used for the next startup of the device.
For a device supporting main and backup configuration files, this command displays the main
configuration file to be used for the next system startup.
If the system is not specified with a configuration file for the next startup or the specified configuration
file does not exist, no information will be displayed when you execute the display saved-configuration
command.
Related commands: save, reset saved-configuration; display current-configuration in Basic
System Configuration Commands.
Examples
# Display the configuration file saved for the next startup of the device.
<Sysname> display saved-configuration
#
version 5.20, Test 5310
#
sysname Sysname
#
domain default enable system
#
telnet server enable
#
multicast routing-enable
#
vlan 1
#
vlan 999
#
domain system
access-limit disable
state active
idle-cut disable
self-service-url disable
#
To Next Page
Loading...
Need help?
General