1-36
A new device in the topology information is identified based on the standard topology. After you add a
device into a cluster, if you do not use the topology accept command to confirm the current topology
and save it as the standard topology, this device is still regarded as a new device.
display cluster members
Syntax
display cluster members [ member-number | verbose ]
View
Any view
Default Level
1: Monitor level
Parameters
member-number: Number of the member device, in the range 0 to 255.
verbose: Displays the detailed information about all the devices in a cluster.
Description
Use the display cluster members command to display the information about cluster members.
Note that this command can be executed on the management device only.
Examples
# Display the information about all the devices in a cluster.
<aaa_0.Sysname> display cluster members
SN Device MAC Address Status Name
0 S3100 00e0-fc00-1751 Admin aaa_0.Sysname
2 S3100 00e0-fc00-3199 Up aaa_2.S5120_4
3 Sysname S3528P 00e0-fd00-0043 Up aaa_3.S5120
4 S3100 00e0-fc00-2579 Up aaa_4.S5120_2
5 S3100 000f-e20f-c415 Up aaa_5.S5120_5
Table 1-10 display cluster members command output description
Field Description
SN Member number
Device Device model
MAC Address MAC address of a device
To Next Page
Loading...
Need help?
General