Mazda 626 1981 - 05-12

Fig. 6- 41
Fig.
5-
42
Fig. 6- 43
Fig.
5-44
5
6.
Pick-up coil and ignitor assembly.
7.
Remove the clip holding the vacuum diaphragm
link.
Then, remove the screws attaching the vacuum
control unit to the housing and remove the vacuum
control unit.
8.
Loosen the screws attaching the signal plate and
remove the signal plate.
9.
Loosen the screws attaching plate and remove the
plate.
10. Drive the retaining pin
out
of
the driver geat with
a drift and remove the gear.
11. Remove the drive shaft assembly through the
top
of
the distributor housing.
12.
Oil
seal
5 : 12