9
Fig.
9-9
Fig.
9-10
•
Fig.
9-11
9 : 3
9-B.
REAR
AXLE
REMOVAL
Jack up the vehicle until the rear wheels are clear
of
the ground and support with stands.
After draining the oil
(using the wrench 49
0259 730),
remove
the
following parts in numerical order.
l.
Rear axle shaft (refer to
Par.
9-A-1)
2. Propeller shaft (refer
to
Par.
8-A)
3. Rear axle
9-C
. REAR
AXLE
DISASSEMBLY
9-C-1.
Removing
Differential
Mount the rear axle on the engine stand (49
0107 680A)
with
attachment
(49
0419
561
and
49
0223
561A).
Apply identification punch marks on the carrier,
differential bearing caps and adjusters for reassembly
purpose.
Remove
the
following parts from the carrier.
1.
Adjuster lock plates and bolts
2.
Bearing caps and bolts
3. Adjusters
4.
Differential assembly and bearings
Note:
Make certain
that
each bearing outer
race rem1ins
with its respective bearing.
To Next Page
Loading...
