Mazda 626 1981 - 02-03

2
Fig. 2- 9
Fig.
2-10
Fig.
2
-1
1
Fig.
2-12
2 : 3
2- A- 4.
Assembling
Oil
Pump
Carry
out
the disassembling operations in the reverse
order.
Note:
When
installing
the rotors into
the
body, be sure
that
the
tally
marks
on
the rotors go toward the cover.
2-A-5.
Installing Oil
Pump
Install the oil pump in the reverse order
of
removing.
Adjust the slack
of
chain as shown
in
Fig.
1-
71.
2- B. CHECKING
OIL
PRESSURE
Warm
up the engine
to
the normal operating tempera-
ture. Remove the oil pressure switch and connect the
oil
pressure gauge (49
0187 280)
instead.
The normal oil pressure
is
as
follows:
Oil
Pressure
3.5
-
4.5
kg
/cm2
(50
-
64
lb/in2)
at
3,000
rpm
of
engine
2-C
.
OIL
FILTER
To replace, proceed
as
follows:
l. Remove the oil
filter
cartridge with a suitable wrench.
2. Apply
o
il
onto
the oil seal on a new filter cartridge.
3.
Install the cartridge
onto
the cover and tighten
the
ca
rtridge fully
by
hand.
4.
Start
the engine and check
that
the joints are not
leaking. Top
up
with o
il
if
necessary.