Mazda 626 1981 - 10-11

10
Fig.10-39
Ident
ific
ation
marks
Identi
ficat
ion
marks
Sector
shaft
Pitman arm
Fig.
10-40
Fig
.10-41
•
10
: 11
10-C-3
.
Replacing Pitman
Arm
Raise
the
front
end
of
the
vehicle and
support
with
stands.
Remove
the
pitman
arm
in
the
numerical order.
1.
Front
wheel
2.
Center
link from
pitman
arm
use
the
puller
(49
0118
850C)
3.
Pitman
arm
from sector shaft
use
the
puller
(49
0223
695E)
Install
the
pitman
arm in
the
reverse
order
of
removing.
Note:
Install
the
pitman
arm
onto
the
sector
s
haft
, aligning
the
identification marks
of
the
pitman arm
and
sector
shaft
.
Tightening
torque:
Note:
Pitman arm
to
sector shaft:
8.0
-
12
.0
m-kg
(58
-
87
ft
-lb)
Pitman
arm
to
center
link:
3.0
-
4
.5
m-kg
(22
-
33
ft-lb)
Insta
ll
a new
split
pin.
10-C-4
.
Replacing Tie-rod
Raise
the
front
end
of
the
vehicle and
support
with
stands.
Remove
the
tie-rod
in
the
numer
ical order.
1.
Front
wheel
2.
Split pins
and
nuts
3.
Tie
-
rod
from
center
link and knuckle
arm
use
the
puller
(49
0118
850C)
Install
the
tie-
rod
in
the
reverse
order
of
removing.
No
te:
a) Whenever
the
tie-rod
or
ball
joint
is
replaced,
the
toe-in
must
be reset.
b) Tighten
the
nuts
to
3.0 "" 4.5
m-kg (22
-
33
ft
-lb).
c)
Insta
ll
a new
split
pin.