Mazda 626 1981 - 14-05

14
Mould
remover
Fig.
1
4-
17
Fig.
14-18
·
~
Fig. 1
4-
19
Fig.
14-20
14:
s
Insert the mould remover between the mould and the
glass, and pull the retaining clip with
it.
6.
Windshield mould
Note:
Place
the
masking tape
on
the
instrument
panel
near
the
windshield glass
to
prevent any damage.
Mak
e a hole through the sealant with a needle. Then,
pass the piano wire through this hole and wrap each
end round a bar.
Cut through the sealant by moving the wire back and
forth. Keep the
wfre
in constant contact with the
glass
so as not
to
damage the paint.
7. Windshield
glass
14
- E-
2.
Installing Windshield Glass
1.
Using
the cutting knife, cut the sealant
off
smoothly
so that 1
-
2
mm
(0.04 - 0.08
in)
of
the sealant
remains along the glass opening flange.
If
the thickness
of
the
se
alant left along the
glass
opening flange
is
too
small, first, clean with a solvent.
Then, apply primer with the brush and leave
it
to
dry for
20
-
30
minutes.
Then, apply sealant until
a thickness
of
1
-
2
mm
(0.04 - 0.
08
in)
is
obtained.
...
·